Lasko Fan 3012 User Manual download pdf (Page 2)

SAVE THESE INSTRUCTIONS

Rev. E 10/08

2084327

Rev. E 10/08

2084327

MODELO 3012 y 3016

Innovators in Home Comfo

Inclinar la Cabeza del Ventilador

hacia atrás. Coloque la REJILLA

TRASERA en el MOTOR.

Alinear la lengüeta de la Rejilla Trasera con

la ranura enla parte superior de la cubierta

delantera del MOTOR.

Asiente la REJILLA y sujetela con la

TUERCA DE PLÁSTICO. HACIA LA

DERECHA.

Deslice la HÉLICE en el EJE del MOTOR. (Alinear la Ranura Del Cubo de la

TAPA con el Pasador del Eje del Motor.)

Instale el ADORNO. Inserte las PATITAS en

las RANURAS rectangulares. Apriete para

asegurar.

Para asegurar la PALETA, enroscarla hasta

que quede apretada en el CUBO DE LA TAPA

haciéndola girar HACIA LA IZUIERDA.

Con la Cabeza del Ventilador inclinada hacia atrás y centrada, alinear el ADORNO

de tal manera que la divisa quede horizontal. Insertar la parte inferior de la REJILLA

DELANTERA dentro de la REJILLA TRASERA. La proyección de la parte inferior de

la REJILLA TRASERA debe quedar entre dos Alambres de la parte delantera. Cerrar

apretando la parte delantera contra la parte trasera empezando en la parte superior

y continuar cerrando hacia abajo ambos lados. NO NECESITO EL GANCHOS DE

LA REJILLA PARA ENSAMBLE.

MOTOR

REJILLA

TRASERA

MOTOR

TUERCA DE

PLÁSTICO

HÉLICE

TAPA DE

VENTILADOR DE

16"

RANURA

Adorno: Vista Lateral

APÉNDICE

PUNTO

CIERRE

ADORNO

RANURA

DEL CUBO

PATITA

REJILLA

TRASERA

PASADOR

TAPA DE

VENTILADOR DE

12"

PUNTO

CIERRE

APÉNDICE

FUNCIONAMIENTO

1. Cuidadosamente retire el Ventilador de la bolsa plástica y la caja. Arme la unidad siguiendo estas instrucciones.

2. Conecte el cable eléctrico a un tomacorriente de 120 voltios.

3. Después de apagar el Ventilador, desconecte la unidad del tomacorriente eléctrico.

Asegúrese que el enchufe encaje ﬁrmemente en el tomacorriente.

Cuando los enchufes quedan ﬂojos en los tomacorrientes, pueden deslizarse parcial o completamente fuera del tomacorriente con

un leve movimiento del cable adosado. Los tomacorrientes en este estado podrían sobrecalentarse y representar un grave

peligro de incendio; si está cubierto por una cortina o tela, el riesgo de incendio es aún mayor.

MODEL 5132

Read all instructions before using this Fan.

1. Make certain the power source conforms to the electrical requirements of the Fan.

2. Make certain that the room is equipped with a working smoke detector.

3. Use this Fan only as described in this manual. Any other use not recommended by the manufacturer may cause ﬁre, electrical shock,

or injury to persons.

4. To reduce the risk of personal injury and electric shock, the Fan should not be played with or placed where small children can reach it.

5. Unplug power cord before installing, servicing, or moving the Fan.

DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN SERVICING

OR MOVING THE FAN. ALWAYS UNPLUG THE POWER CORD. ALWAYS TURN OFF AND UNPLUG FAN BEFORE

LEAVING THE AREA. NEVER LEAVE CHILDREN UNATTENDED WHEN THE FAN IS ON OR PLUGGED IN.

REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK - DO NOT USE THIS FAN WITH ANY SOLID STATE SPEED

CONTROL DEVICES.

WARNING: USE OF A THREE-PRONG TO TWO-PRONG ADAPTER IS NOT RECOMMENDED. IMPROPER CONNECTION MAY CREATE

THE RISK OF ELECTROCUTION. USE OF SUCH ADAPTERS IS NOT PERMITTED IN CANADA.

WARNING: THIS PLUG IS A SAFETY FEATURE. TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND PERSONAL INJURY, DO NOT

REMOVE, REPLACE, REPAIR OR TAMPER WITH THE ORIGINALLY SUPPLIED PLUG. IF THE FAN DOES NOT FUNCTION PROPERLY,

IT MAY BE DUE TO THE SAFETY DEVICE INCORPORATED IN THIS PLUG. RETURN TO AN AUTHORIZED SERVICE CENTER OR CALL

800-233-0268, MONDAY - FRIDAY, BETWEEN 8:00 AM AND 5:00 PM EST. IF THE PLUG WARNING LABEL IS MISSING OR DAMAGED,

CALL THE TOLL FREE NUMBER FOR A REPLACEMENT LABEL.

6. This Fan must NOT be used in potentially dangerous locations such as ﬂammable, explosive, chemical-laden or wet atmospheres

where gasoline, paint or ﬂammable liquids are used or stored.

7. Where possible, avoid the use of extension cords because the extension cord may overheat and cause a ﬁre. If you must use an exten-

sion cord, minimize the risk of overheating by using the shortest cord possible and ensuring that it is UL listed. NEVER use a single

extension cord to operate more than one Fan.

8. The power cord is equipped with a three-prong grounded plug that must be inserted into a matching receptacle. Under no cir-

cumstances must the grounding prong be cut off the plug. Where a two-prong wall receptacle is encountered, it must be replaced

with a properly grounded three-prong receptacle installed in accordance with the National Electrical Code (NEC) and all applicable

local codes and ordinances. This work must be done only by a qualiﬁed electrician, using copper wire only.

9. NEVER operate any Fan with a damaged cord or plug or after the Fan malfunctions, has been dropped or damaged in any manner.

Return Fan to an authorized service facility for examination, electrical or mechanical adjustment or repair.

10. NEVER insert or allow ﬁngers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock or ﬁre,

or damage the Fan. To reduce the risk of ﬁre, DO NOT block or tamper with the Fan in any manner while it is in operation.

11. Always place the Fan on a stable, ﬂat, level surface when operating, to avoid the chance of the Fan overturning. Locate the Power

Cord so the Fan or other objects are not resting on it. DO NOT run Power Cord under carpeting. DO NOT cover Power Cord with

throw rugs, runners or the like. Arrange Power Cord away from room trafﬁc and where it will not be tripped over.

12. This Fan is not intended for use in wet or damp locations. Never locate a Fan where it may fall into a bathtub or other water container.

NEVER use Fan where ﬂammable liquids are used or stored.

13. NEVER use Fan outdoors.

14. This Fan is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are conﬁned. Please

refer to National Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical require-

ments for Agricultural Buildings. THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).

15. This Fan is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state

or local codes or standards relating to electrical requirements for Hazardous locations. THIS FAN DOES NOT MEET

THE REQUIREMENTS OF NEC ARTICLE 500 (2008).

MODEL 3012 and 3016

GENERAL SAFETY INFORMATION

When using electrical appliances, basic precautions should always

be followed to reduce the risk of ﬁre, electric shock and injury to persons,

including the following:

INSTALACIÓN

1. Coloque un perno prisionero detrás de la pared. Si no puede encontrar un perno prisionero, usted podrá encontrar tipos especiales

de pernos de anclaje en su ferretería local.

2. Fije la Placa de Montaje a la pared con los Tornillos que vienen incluidos (Tornillos para Madera #8 X 1 1/4"). Procure que la brida

apunte hacia arriba.

3. El Ventilador ahora está listo para ser colgado en la Placa de Montaje.

1 2 3 4

Comments to this Manuals

No comments

Lasko Fan 3012 User Manual Page 2

Comments to this Manuals

Related products and manuals for Household fans Lasko Fan 3012